pipes

Carbon iron

Is an iron-carbon alloy
It consists of mixing two elements, iron and carbon.
Other elements are present in very small quantities.

  • A106 grade B

  • API 5L grade B X52

Stainless steel:

It is one of the best metal products that are more resistant to rust, dirt and corrosion than ordinary steel.
Is an iron-carbon alloy

304, 304L

Standard 18/8 grades

316, 316L

Improved resistance to pitting corrosion in chloride environments

Fittings and accessories

Elbows

The elbow provides a change in the direction of material flow.
This adds stress to the system due to impact, friction and re-acceleration.
When the product enters the elbow is usually continues to move straight forward to the first area of impact.
Then the product is deflected at an angle towards the elbow outlet.
The deflection angle is determined from the elbow design and product properties, as well as the transmission speed and the specific load.

Elbows

ANSI B16.9 / MSS-SP75

DIN2605 Teil 1 / Teil 2

Types

45 DEGREE

90 DEGREE

180 DEGREE

GRADE

ANSI B16.28

WPB / WPL 6

Radius

SHORT Radius

LONG Radius

Reducers

There is in the pipeline and its function is to reduce the pipe size from a larger bore to a smaller bore (inner diameter)
The size of the reduction is usually equal to the average diameter of the largest and smallest pipe.
Types: reducers (1) centralized (2) and decentralized.
The reducer
There is in the pipeline and its function is to reduce the pipe size from a larger bore to a smaller bore (inner diameter)
The size of the reduction is usually equal to the average diameter of the largest and smallest pipe.
Types: (1) centralized (2) decentralized.
Concentric reducers:
It is in a conical shape, and its function is when there is a shift in diameter between the tubes.
For example:
When a 1-inch tube goes to a 3/4-inch tube, the top or bottom of the tube does not need to remain flat.
Unlike eccentric decreases, concentric decreases have a common central line.
Decentralized reducers:
Fittings used in piping systems between two pipes of different diameters.
It is used when the diameter of the pipe on the upper side of the fitting (ie where the flow comes from) is greater than the lower side.

Reducers

ANSI / MSS

DIN2615 Teil 1 / Teil 2

Plugs:

It is a cap to close the end of the tube.
It is available for all pipe diameters.
It is used to close large diameter pipes.

Caps

ANSI / MSS

DIN2617 / DIN28011

Tee or connections

Fittings used to split and change the direction of flow of the operating tube.
It is in two types:
Equal Tee:
Its main function: to create a branch at an angle of 90 degrees from the main path of the tube.
The equal tee (or straight tee) is used as the branch has the same diameter as the run-pipe.
Reducing Tee:
The Reducing Tee is used because the diameter of the branch is smaller as the operating tube.

Reducers ANSI / MSS DIN2615 Teil 1 / Teil 2